Scapa Tapes North America
RX630P
Medical Heat Sealable Tape
Bioflexr RX630P is a 9.75 mil, medical heat sealable tape. It is primarily used for applications that require heat for bonding. Unwind this product and combine the adhesive side to the surface of the substrate that will be bonded. This should be done by using a heated (190° F/88C minimum) squeeze roll or other method which ensures firm pressure, heat and intimate contact of the adhesive to the bonding surface. Recommended application temperature to bond adhesive to substrate(s) is 65° and above. Proper bonding will occur unless adhesive and substrate material(s) are at 65° or above. After inital bonding, the substrate must be cooled to room temeperature before the adhesive regains its non-blocking characteristics. A hot platen press is recommended for heat bondings. Peel strength and holding power can vary depending on substrate, heat seal temperature, dwell time, and pressure. Generally speaking, bond strengths are significantly higher than pressure sensitive films.
| Backing/Carrier | PET - Polyester |
|---|---|
| Adhesive | |
| Thickness | 9.75 Mils |
| Tensile | |
|---|---|
| Elongation | |
| Adhesive Activation | Heat |
| Adhesion (unwind) | 43 oz/in |
| Min. Application Temp | 65° F |
|---|---|
| Min. Service Temp | 0° F |
| Max Short-Term Temp | |
| Max Long-Term Temp |
Product Features
- Dimensionally stable due to thick polyester carrier
- Adheres well to a wide variety of surfaces
- Low bonding temperature allows use on temperature sensitive substrates
- Adhesive film has no tack and is ideal where stacking of parts without liner is required
- Thermoplastic adhesive can be reactivated
- For bonding: 190°F/88°C = 4-20 sec. = 30-50 psi min.
- 250°F/138°C = 1-2 sec. = 30-50 psi min.
- 300°/149°C < 1 sec. = 30-50 psi min.
- Release liner thickness (42# kraft) = 1.5 mil
- Adhesion to release (QCTM 034) 300"/minute @ 135@deg angle = 5g/25mm
- Product Safety: Approved for indirect food contact (21 CFR 175.105 FDA indirect food additive)
- Contains no natural latex proteins
Adhesive Tape Applications
- Applications that require heat for bonding
Adhesive Tape Colors
- Clear
Converting Services
Precision Cutting, Die Cutting, Slitting, Printing, Laminating and Coating, Spooling and Finishing, Consulting & Process Audit, Prototyping, Inventory Management
At Budnick, we specialize in custom converting these materials into labor saving, user-friendly parts.
Data provided by Budnick Converting, Inc.
The physical properties listed are typical values and are not to be considered as specifications. Our suggestions for use are based on tests we believe to be reliable. However, the purchaser must carry out their own tests to determine the suitability of the product for their internal use. Information is given in good faith, but without warranty.
It is essential, as with all pressure-sensitive tapes, that the surface to which the tape is applied be clean, dry and free of grease and oil.
Shelf life from date of manufacture is based on the product being stored at 70°F(21°C) / 50% relative humidity out of direct sunlight.
Specification compliance is dynamic and should only be used as a general guide. Always confirm that the tape you are interested in currently complies with all specification requirements. Please verify that the product number that you select is available in the proper size and color to meet your specification.